Bellinzoni IDEA HP Hydro oil repellent to Natural Look

IDEA HP Hydro oil repellent to Natural Look

It is a specific solvent-based transparent stain for the protection of buildings and stones aganist the penetration of water, oils, grease and moisture. It allows the stone to breathe. Penetrates deep into the stone and does not change the original color. It does not create any film and gives stone excellent protection. the treated stone does not change color after exposure to UV rays. It prevents the formation of mold and has antifreese action.

Techinical data

• Appearance: Liquid;
• Color: transparent; Specific gravity at 20 ° C 0.80 ± 0.05;
• Solubility in water: Insoluble;
• Drying time at 20 ° C (68 ° F) 45-60 minutes;
• Complete drying: 8 hours; Full curing: 3 days;
• Storage: at 20 ° C away from heat, moisture, sunlight. 24 months in original packaging

 APPLICATION

Surface preparation:

The surface must be dry and clean; possibly stains, mildew, crusting must be
removed, otherwise their subsequent removal would be difficult.

Application:

Brush, roller, mop, fleece. It is recommended, where possible, brush application as it allows better penetration protection. To use, apply IDEA HP with a brush, pressing lightly to make it penetrate well into the cracks, corners and cavities. It is also possible to apply the protective using a dispenser to spray at low pressure, at a distance of 20-25 cm from the surface and taking care to dab any sagging. Allow the product to air and the material will be protected. If after the application there were any surplus, remove them by rubbing with a rag soaked in the product and in order dab with a dry cloth. During the application and subsequent drying, the temperature of the substrate should be between 10 and 30 ° C. In case of application of the floor with underfloor heating, turn off the heater and let the stone cool completely.

DIRECTIONS FOR USE

• It is advisable to apply the product until complete saturation of the stone.
• On highly absorbent material it is recommended to apply the product 2 times in 2 hours after the first application.
• Do not dilute the product with other solvents or water as the preparation is ready for use.
• The material to be treated must be completely dry.
• Another application system, suitable for small pieces, may be the one for immersion; you can also use a sponge with product and dab the material.
• Once treated, the stone material must be allowed to dry for 24 hours to complete polymerization occurs.
• In the case of treatment of statues, vases or decorative items outside, pay close attention to the gaps.
• Before use read the recommendations printed on the label and always carry out a preliminary test.

AREAS OF APPLICATION

Marble, granite, terrazzo, marble-agglomerate, Quartz-agglomeration, stone.

APPROXIMATE COVERAGE PRODUCT

For the protection of marble and granite with a liter of the product you can be treated 15/25 m2. Depending on the type and degree of finishing of the
material. In the case of limestone, sandstone, marble / concrete with one liter you can treat 10-15 m2.

MAINTENANCE

For the maintenance of the material we recommend the use of our cleaner LEM3. In case of wear of the stone and as required,
We recommend a re-application of the product.