Idea Black Bellinzoni

IDEA DARK - Protective for stones EFFECT DARKENING - Bellinzoni

Bellinzoni IDEA BLACK is Protective, hydro-oil-repellent impregnating for the treatment of surfaces shiny and rough type of natural stone granite, marble etc. Particularly suitable for black or dark absorbing stones. IDEA BLACK intensifies the natural colors of the stone, can conceals scratches the flaws and imperfections of dark / black stone. IDEA BLACK has excellent penetration, it does not form a film on the surface of the stone and wicks. No yellowing, and is ideal for the treatment of stone laid in indoor and outdoor; It is resistant to the effect of water and dirt. It is great for shiny materials, wicks stone, blocks the leakage of efflorescence, penetrates deep, particularly enhances coloration of the treated material, does not create any unsightly film. Laboratory tests demonstrate the UV resistance of the product. It prevents the formation of mold. The product can be used for the treatment of agglomerates of quartz-resin and gres.

CHEMICAL

• Liquid appearance
• Transparent color
• Odour Characteristic
• Specific weight at 20 ° C 0.85 ± 0.05
• Solubility in water Insoluble
• pH N.A.
• Drying time at 20 ° C (68 ° F) 45-60 minutes *
• Hard Dry 8 hours *
• Full cure 7 days *
• Resistance to ultraviolet rays
• Long wave (365 nm) Excellent (no variation after 24 hours)
• Shortwave (254 nm) Excellent (no variation after 24 hours)

INSTRUCTIONS FOR USE

Surface preparation:

The surface must be dry and clean; possibly to stains, mildew, crusting must be removed, otherwise their subsequent removal would be difficult.

Application:

Brush, roller, mop, fleece. It is recommended, where possible, brush application as it allows better penetration protection. To use, apply the product with a brush, pressing lightly to make it penetrate well into the cracks, corners and cavities. It is also possible to apply the protective using a dispenser to spray at low pressure, at a distance of 20-25 cm from the surface and taking care to dab any sagging. Allow the product to air and the material will be protected. If after the application there were any surplus, remove them by rubbing with a rag soaked in the product and in order dab with a dry cloth. During the application and subsequent drying, the temperature of the substrate should be between 10 and 30 ° C. In case of application of the floor with underfloor heating, turn off the heater and let the stone cool completely.

DIRECTIONS FOR USE

• It is advisable to apply the product until complete saturation of the stone.
• On highly absorbent material it is recommended to apply the product at least 2 times at 2 hours after the first application.
• Do not dilute the product with other solvents or water as the preparation is ready for use.
• The material to be treated must be completely dry.
• Another application system, suitable for small pieces, may be the one for immersion; you can also use a sponge with product and dab the material.
• In the case of treatment of statues, vases or decorative items outside, pay close attention to the gaps.
• Before use read the recommendations printed on the label and always carry out a preliminary test.

AREAS OF APPLICATION

Marble, granite, terrazzo, marble-agglomerate quartz-agglomeration, stone.

APPROXIMATE COVERAGE PRODUCT

For the protection of glossy or polished marble and granite more than 800 grain with one liter you can treat 15-20 m2, while in the case of limestone, sandstones, polished marble / concrete with the same finish, the yield can be slightly lower. The treatment of absorbent stones or rough finish may require a greater use of the product, with an indicative spreading rate of around 10 m².

MAINTENANCE

For the maintenance of the material we recommend the use of our LEM-3 detergent. In case of wear of the stone and as required. We recommend a re-application of the product.