Idea Gold High Performance water and oil repellent

Idea Gold High Performance water and oil repellent

Hydro oil repellent "Idea Gold" Bellinzoni is a stain based on nanotechnology formulation that protects marble granite and stones. Idea Gold is a transparent protective used for maximum protection of all stone surfaces, against penetration of water, oil, fats and moisture. It also great on glossy materials, it lets the stone breathe, blocks the leakage of efflorescence, penetrates deep, it does not alter the natural color of the treated surface and does not create any unsightly film. Spectacular effect "pearly": the water droplets are disposed on the treated surface in the form of balls, which roll off on sloping surfaces or immediately following a puff of air.

CHEMICAL

• Liquid appearance
• Transparent color
• Characteristic odor of solvent
• Specific weight at 20 °C 0.80 ± 0.05
• Solubility in water Insoluble
• pH N.A.
• Drying time at 20 °C (68 ° F) 45-60 minutes *
• Hard Dry 8 hours *
• Full cure 7 days *
• Resistance to ultraviolet rays
• Long wave (365 nm) Excellent (no variation after 24 hours)
• Shortwave (254 nm) Excellent (no variation after 24 hours)

INSTRUCTIONS FOR USE

• Surface preparation: the surface must be dry and clean; possibly stains, mildew, crusting must be removed
• away, otherwise their subsequent removal would be difficult. Application: brush, roller, spray, cloth. It is suggested, when
• possible, brush application as it allows better penetration protection. To use, apply with a GOLD IDEA
• brush, pressing lightly to make it penetrate into cracks, corners and cavities. You can also apply the protective
• using a dispenser to spray at low pressure, at a distance of 20-25 cm from the surface and taking care to dab any
• sagging. Allow the product to air and the material will be protected If after application there were any surplus,
• remove them by rubbing with a rag soaked in the product and in order dab with a dry cloth.
• during the application and subsequent drying, the temperature of the substrate should be between 10 and 30 ° C. In the case of application of
• floor with underfloor heating, turn off the heater and let the stone cool completely.

DIRECTIONS FOR USE

It is advisable to apply the product until complete saturation of the stone.
On highly absorbent material it is recommended to apply the product at least 2 times at 2 hours after the first application.
Once treated, the stone must be left to dry for 8 hours to complete the polymerization. the polymerization
Full will be 7 days.
Do not dilute the product with other solvents or water as the preparation is ready for use.
The material to be treated must be completely dry.
Another application system, suitable for small pieces, may be the one for immersion; you can also use a
sponge with product and dab the material.
Once treated, the stone material must be allowed to dry for 7 days to complete polymerization occurs.
In the case of treatment of statues, vases or decorative items outside, pay close attention to the gaps.
Before use read the print on the label recommendations.

AREAS OF APPLICATION

Marble, granite, terrazzo, marble-agglomerate quartz-agglomeration, stone, limestone, sand stone.

TOOLS FOR APPLICATION

Brush - Roller - Vello spreader - Mop - spray dispenser

APPROXIMATE COVERAGE PRODUCT

For the protection of marble and granite with a liter of the product you can be treated 15/25 m2. Depending on the type and degree of finishing of the
material. In the case of limestone, sandstone, marble / concrete with one liter you can treat 10-15 m2.

Maintenance

For the maintenance of the material we recommend the use of our LEM-3 detergent. In case of of the stone and as required,
We recommend a re-application of the product.