Strip Vapor Anti Graffiti Bellinzoni Lt.1

STRIP VAPOR BELLINZONI LT.1

Bellinzoni is an anti-graffiti product for the protection of exterior facades, statues, decorations, walls to be written made with tempera paints and most spray paints on the market. Through the use of the Strip Vapor we create a non-visible protective film which closes the pores of the material not allowing the paint to penetrate inside. Thanks to its use cleaning graffiti will be done through the use of high pressure cleaner with hot water or steam jets.

Chemical characteristics

Liquid appearance
White color
Odorless odor
Specific gravity at 20 ° C 1.00 ± 0.05
Solubility in water Soluble
pH 8.5 ± 0.05
Instructions for Use
Surface preparation: the surface must be dry and clean; possibly stains, mildew, crusting must be taken away, would otherwise be encapsulated and protected by the resin films and their subsequent removal would be difficult.

Application

Cloth, brush, roller or spray.

Apply STRIP VAPOR on the surface to be treated, taking care to apply it evenly. For a good impregnation is recommended to apply 2 coats. Once applied, STRIP VAPOR gives a light satin effect to the surface; if you wanted to rub it is necessary to gently rub with a cloth. The anti-graffiti will start its function after about 12 hours (curing time).

Removal

In the case where the treated surfaces are stained by graffiti and written with spray or liquid paints, it is possible to remove the written with steam or with hot water in order to dissolve the protective and consequently remove the paint. Alternatively, you can take action by mechanical action using abrasive pads such as Scotch Brite ® or brushes. If the paint is not removed in its entirety, you can use our. Paint stripper WALL CLEAN. After removal, it is necessary to repeat the application of STRIP VAPOR to continue the protection.

Advice for application

On highly absorbent material, It is recommended to apply the product at least 2 times to 30 minutes after the first application. The material to be treated must be dry. In the case of treatment of statues, vases or decorative items outside, pay close attention to the gaps. Before use read the recommendations printed on the label and always carry out a preliminary test.

Application surfaces

Marble, granite, marble / concrete, marble / resin, limestone, brick, brick and concrete.

Approximate Product Yield

For the protection of marble and shiny or polished granite over 800 grit with this product you can treat 10/15 m2. In the case of limestone, sandstones, polished or honed marble / cement over the 800 grit with this product can treat lt 5/10 m2.